Totaline Wireless Thermostat & Receiver Combo
- Calculated at Checkout
For a replacement of this product, please contact us.
P474-1100RF_P474-1100REC (combines P474-1100RF wireless thermostat and P474-1100REC receiver)
Did you ever wish you could turn up the heat without getting out of your warm cozy bed? Or that you could turn down the air conditioning from your living room chair? Or put the thermostat in a newborn baby's room to keep the temperature exactly right? If you wish to be able to move the thermostat, put it by your bedside at night, or even control your heating and air conditioning system from two different places, such as upstairs and downstairs, then the Totaline Wireless Thermostat is for you.
Here's how it works: Remove your old wall thermostat, replace it with the Totaline receiver and then remotely control the temperature anywhere in your house with the Totaline thermostat. Add additional wireless thermostats (see below) around your house (up to 4) and have instant access to temperature control no matter where you are.
This kit consists of two parts, a thermostat and a receiver. The thermostat is a wireless, battery operated unit that can be placed in any location in your home (up to 500ft. from receiver) and will transmit radio signals to the receiver which replaces your existing wall thermostat. This thermostat allows up to 4 time/temperature settings to be programmed per 24-hr period and stores programs for 7 independent days.
Place Receiver Wherever Wires Are Available
The receiver is easy to install and is wired just like a standard 24VAC thermostat. Connect the unit wherever existing wires are available; the old thermostat location, in a furnace closet, in an attic or basement.
Place Thermostat in Most Important Rooms
Once the receiver is installed, the thermostat can then go anywhere in the building, and it will transmit radio signals back to the receiver. The transmission range is up to 500 feet, and it works through walls, floors, ceilings, etc. The temperature sensor is located on the thermostat, so place the thermostat where temperature control is most important to you
- Wireless remote control thermostat
- 7 Day Programmable with 4 time periods per day and holiday mode
- Backlit display shows large numbers as well as the heating/cooling set point, and room temperature
- Can be manually operated or programmed for energy savings
- Up to 4 thermostats can be used with one receiver
- Transmits up to 500 feet, through walls and floors
IMPORTANT!!! - PLEASE NOTE:- 2 Wire Heating Only Thermostats.
Please note that two wire thermostats are not capable of providing continuous voltage to the receiver while supporting operation of your HVAC equipment. If your home has only two thermostat wires (on heating only systems), you can still use this product if you find the receiver a place where you are able to provide continuous 24 Volts to the receiver. The receiver does not sense temperature and therefore does not need to be located in your home's living area. If your HVAC equipment supplies 24 Volts (you can test this with an volt meter across the thermostat wires), locating the receiver near the HVAC equipment will allow you to connect an additional wire to the receiver's Common terminal and therefore provide continuous 24 Volts.
Additional Tip: Often home builders install thermostat cable with additional unused wires for future expansion. If these wires are not being used by your present thermostat, they might be coiled behind the thermostat faceplate or pushed into the wall. One of these unused wires could be used to supply continuous 24 Volts to the receiver at your present thermostat location.
BEST SOLUTION: For 2-wire installation, order this two wire kit Power Adapter separately: ACC0436. It contains a plug in 24v transformer and a relay that allows control of 2 wire heat only systems
Contact an Rfwel Wireless Support Specialist for installation assistance.